CHEAPEST MATERIAL TO COVER WALL STUDS INSTALL
CHEAPEST MATERIAL TO COVER WALL STUDS PROFESSIONAL

Cut and place the studs against the wall, seated in the lap joints.Start by fitting the studs against the existing walls, where you’ve cut lap joints on the floor and ceiling plates. In comparison, if using 12.5mm plasterboard, the distance between centres must be a maximum of 600mm. If using 9.5mm thick plasterboard, the studs must have a distance between centres of no more than 400mm. Bore holes in the ceiling plate at the correct places for electrical cables or plumbing pipes.

CHEAPEST MATERIAL TO COVER WALL STUDS INSTALL

Install the ceiling plate in the same way as the floor plate, fixing it to ceiling joists with screws.

If you intend to add a door, you must leave a gap in the floor plate.

However, ensure there aren’t any hidden cables or pipes in the way.

Drill and screw timber floorplate to the floor joists.

Where the floorplate meets an existing wall, cut a half-lap joint to receive a vertical stud’s lower end.

Cut half-lap joints and screw the laps together on internal and external corners.

Using the floor chalk marks as a guide, cut the timber to correct lengths.

However, if there aren’t any in the correct location, you must provide adequate support at these locations.

Find the location of existing wall studs, floor and ceiling joists and mark them as places to securely fix the stud wall.

Finally, chalk the layout onto the ceiling. Then, use a spirit level to transfer the lines up the wall.

Draw the wall layout on the floor using a chalk line.

Remember, ceiling lights are usually in the centre of the room and light switches are next to a door.

Reroute services to provide electrical sockets, light locations and switches, and radiators.

Then, remove radiators, light switches, ceiling roses, and electrical sockets that might be in the way of the new wall.

Ensure floor and ceiling are horizontal, so you know where gaps need sorting out.

Always add on 10% for materials as there will be wastage when cutting timber and plasterboard.

Measure the proposed wall length to buy the correct amount of materials.

Gloves – To protect your hands from fibreglass irritation and wood splinters.

Safety glasses – To prevent dust from entering the eyes.

Dust mask – To prevent dust inhalation when cutting wood, fibreglass insulation and plasterboard.

Therefore, this must be done by a professional.Īnyone who produces dust from plasterboard, cutting wood or handling insulation must wear suitable personal protection. However, load-bearing (or structural) walls must have input from a structural engineer, the calculations approved, and work inspected by Building Control.

Note that it’s pretty safe for anyone to construct non-load bearing walls. Let’s go through the process of building non-loadbearing studwork, so you know what’s involved.

CHEAPEST MATERIAL TO COVER WALL STUDS PROFESSIONAL

Therefore, we recommend you hire a professional every time.

However, you’ll probably take a long time, and you might forget a crucial step. If you’re good at DIY, you can produce a reasonable stud partition wall without using a professional. → Click To Get Quotes Stud Wall Installation Process Generally, the price of materials makes up about 30% of the total cost, while labour charges are the remaining 70%. However, if you want accurate quotations, ask a carpenter, stud wall specialist, or even better, complete the form on this page. Therefore, use them as a start for your research. * We compiled these estimated costs to build a stud wall from various online resources.

Installing Stud Wall with light fittings & radiator

Cheapest material to cover wall studs